| | Sincere apologies
|
|
Hello every one, I sent the unsubscribe request by mistake to the list instead of Fred. take care Amit =) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | Re: msleep function in ICC11?
|
|
Dear Ranjit, I do not know much about ICC11, but if you can get the system time using some function, you can write an empty loop using while{} or do{}while until the time delay is over. Yours sincerely, Nitin (...) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | Re: Type conversion.
|
|
Dear Federico, Typecast the integer into float. ie write the statement as dtemp=(float)temp*3.5 Refer to any C book for information on typecasting. Yours sincerely, Nitin (...) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | Re: please remove me from mailing list
|
|
For getting out of the mailing list, send an e-mail to Fred Martin at fredm@media.mit.edu and not to the mailing list. Read rules sent to you when you first joined the list. (...) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | Re:
|
|
See www-personal.engin.u.../~johannb/ for a detailed paper on EERUF (Error Eliminating Rapid Ultrasonic Firing). Using the algorithm described there, he used 12 sonar sensor at the same time - allthough I don't know if the HB is powerfull enough for (...) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | Re: asm -> icb
|
|
hi, based on the code that some of sent me i wrote a (bash) script for linux, but i still get differences in the "cre" part of the file, and more specifically in all lines after the "*" (all numbers are off by two). any ideas what is going on? (...) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | Re: IR output
|
|
You can connect an IR LED to it. Maybe you may need a series resistor to limit the current through it as well. Basically, the IR LED acts as a transmitter (the same round thing in front of your remote). The demodualator is not a transmitter...it is (...) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | Re: unsubscribe
|
|
dear amit (& others), sending messages to "handyboard" will NOT get you removed from the list. The only way to get removed from the list is to read the instructions and follow them. These instructions may be found at (URL) luck. this may be a (...) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | IR output
|
|
What type of IR component do I need to attach to the Handyboard to allow the IR output to function? Searching the FAQ and documentation only showed the connection circuit up to the point of the header strip. I assume it wouldn't be the same as the (...) (26 years ago, 21-Feb-99, to lugnet.robotics.handyboard)
|
|
| | unsubscribe
|
|
I would like to get off the handy board list for a few days. I am having some email Overflow problems thanks you =) take care Amit Bhavsar (26 years ago, 20-Feb-99, to lugnet.robotics.handyboard)
|