 | | S19 disassembler
|
|
Will someone please point me to an S19 disassember TIA, - - - Nick - - - (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: shaft encoders for a track drive
|
|
Steve Wall wrote: <snip> (...) I've had good results using Hall effect magnetic sensors. I found some 0.1" dia. disk magnets at the hobby shop and embedded them into the holes in some Lego Technic pulley wheels. It's true that only about three (...) (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: sensors
|
|
Hello everyone. =) I'm currently doing research on sensors for a robot my team is building. are there such things as color sensors? any other sensor recommendations would be appreciated =) chen (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
I would like to unsubscribe the mailing list Thank you (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Motors start when reset
|
|
Every time I reset the board, the motor port LEDs light up, if a motor is connected to the motor ports, the motors turn on. This happens until the reset is complete and I hear the beep sound. Is there a way to prevent this? Regards, ...Ameen Suleman (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: shaft encoders for a track drive
|
|
(...) Depending on how your tracks are constructed, if they have holes or slots that light can pass through you can use the tread directly in place of the encoder wheels. Get some detailed information on how optical encoders work, understand it and (...) (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | GREEN MASKING
|
|
Dear Mr Fred Martin, Green masking files are available in Gerber format (pardon me if the spelling is wrong). We do not know how to open these files. Can you send us detailed instructions on how to open these files. Yours sincerely, Nitin (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Stepper Motor
|
|
Keith, I've succesfully connected two steppermotors from old diskdrives to the HB, one 1.8 degrees and one even 0.9 degrees/step. I found all the info I needed on the internet, and especially www.cctc.demon.co.uk...tepper.htm contains some useful (...) (26 years ago, 15-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | re: stepper motors
|
|
I have worked with two kinds of stepper motors with the handy board. One pair was purchased from LMDC. These are Astrosyn miniangles stepper motors. These were big heavy duty stepper motors. The other pair was from old 5 1/4 inch floppy drives from (...) (26 years ago, 15-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Kent Farnsworth's MS-DOS port of pcode
|
|
Thank you ... this is the link that I couldn't find. ftp://cherupakha.med...-c/ms-dos/ - - - Nick - - - (26 years ago, 15-Feb-99, to lugnet.robotics.handyboard)
|
