 | | Re: Motor Driver Chips
|
|
try here: (URL) - - - Nick - - - (...) (26 years ago, 12-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Motor Driver Chips
|
|
www.acroname.com do them... tone (...) (26 years ago, 12-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Motor Driver Chips
|
|
Greetings all! I was wondering if anyone out here knows of a place that carries the TI SN754410 motor driver chips so that I can upgrade the Handy Boards motor drivers to handle more current. Thank you. -- "Only two things are infinite, the universe (...) (26 years ago, 12-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Robot base
|
|
I bought a "Rising Bird Turbo 7" radio controlled car, ripped out the receiver electronics, hooked up 12 rectifier diodes to the motor and a 1W, 10 ohm resistor to the steering electromagnet and bolted a piece of very light wood to the chassis and (...) (26 years ago, 12-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: IR remote problem
|
|
(...) I have seen this occasionally. As long as it's consistent for each key, I think the best bet is to just assume the data size is the larger of the two with trailing 0's for the shorter one. I can't promise this works though, as I've only had a (...) (26 years ago, 12-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | [Fwd: Scotchflex]
|
|
(...) (26 years ago, 12-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | RE: Robot base
|
|
I personally like building my own bases. I don't know about anyone else but I find it more of an achievement if I build everything that went into my robot. -Peter (...) group for quite a while now and I did notice that there seems to be a lack of (...) (26 years ago, 12-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | re: RE
|
|
hi all, my take on the email format issue is that nearly everything should be handled on the client side. in other words, write your filters to deal with the "re's"; figure out that mail is from the handy board list by searching for (...) (26 years ago, 11-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Large circuit construction - How?
|
|
I was going to suggest Scotchflex, but I've always gotten it from a university stockroom. I haven't been able to find it in any of the catalogs I have. Does anyone know any suppliers, besides going to 3M directly? -Scott (...) (26 years ago, 11-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Robot base
|
|
Hi I have been following this mailing list and the comp.robotics.misc news group for quite a while now and I did notice that there seems to be a lack of good quality and reasonably priced robot bases. All the ones I saw where way overpriced or way (...) (26 years ago, 11-Feb-99, to lugnet.robotics.handyboard)
|
