|
|
 | | Re: HB failure
|
| (...) Thanks for your response. When we load the pcode_hb.s19file with the right CONFIG it seems to load properly. We then turn the HB off and back on and try to load the Interactive C. This does not work at the computer says "attempting to linkt to (...) (26 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
| | | | | infrared distance sensor
|
| Hi, I've just received a Sharp Digital Infra-Red Ranging System (GP2D02) and I'd like to connect it to the handyboard. The device clocks the data in on a digitial input but requires the clocking pulses to be no longer than 200 microseconds. This (...) (26 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
| | | | | Re: HB Expansion kit
|
| ---...--- (...) Yes (...) ----6---J2-19 pin ,J19-two 4 pin,J6-4 pin,-one 14 pin for the LCD,-one 4 pin lower r.h. over digital 0,1,2,3. on the hb. All go on the outer edge of the board except J19. Hope this helps, I was also pleased with the kit (...) (26 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
| | | | | Re: ** voltage dropping and current limitting**
|
| (...) Well, just off the top of my head, when you say "get 16 vac out" how are you determining this, a volt meter set for "Volts AC" or some such? Not, say, an oscilloscope? You will note that almost all meters render "AC Voltage" as the RMS (Root (...) (26 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
| | | | | Earlier DL post
|
| Fred- Thank you-it helps when you put the libraries that won't load into the right folder. I shall take up with Newton Labs why the HB won't talk to the HB and says out of date 2.81 code is out of date. Thank you again for all your help. Cappy (...) (26 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
|
|
