 | | Re: Beginner's Help
|
|
Richard, Thanks for the help. I finally got the board to accept the pcode. I acquired a PS/2 mouse to free up my COM1 port. I used the HBDL.exe program that came with the board. After several unsuccessfully attempts to program the board, for some (...) (26 years ago, 15-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | 68hc11a1 x 68hc11a8 and IC hardware
|
|
Hi people! I'd like to know two things: 1) Can I use the 68hc11a8 instead of the 68hc11a1 in the Handyboard, without recompiling Interactive C? 2) What's the minimum hardware to run Interactive C? I just want to blink a led to see if the hb is (...) (26 years ago, 15-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | HB Reset not executing main().
|
|
I built two more Handyboards and I've noticed something odd. When I download a program with a main() function, and reset the board, main() does not get executed. I thought it was supposed to. I'm using IC v3.1 (for the Mac) and Handyboard version (...) (26 years ago, 15-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Beginner's Help
|
|
Make sure that your com port 2 is actually wired to the motherboard I've heard a lot of stories with com ports not working because they forgot to connect the ribbon cable. Check that first. Try booting ito dos and use the DL.exe instead of the HBDL (...) (26 years ago, 15-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Re: some kind of dividing circuit?!?!?!?!
|
|
In reference to your question about the motor with encoders. I know this isn't a software solution, but what if you used an external hardware (chip) counter that reset after 2^(number of bits) clicks. Then send resets as your steps to the (...) (26 years ago, 15-Dec-98, to lugnet.robotics.handyboard)
|
