 | | Thanks
|
|
I'd like to thank everybody who sent me all this valuable information about suppliers and rf link. I think now I can make my handyboard with less then US$ 60.00 without the batteries and motor drivers (I want to use it in data acquisition). As I (...) (28 years ago, 12-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Suppliers and rf link
|
|
Cesar, Nuts & Volts magazine caries lots of adds for just the sort of thing you need (www.nutsvolts.com). I wanted to mention here the 2 X 16 and 2 X 20 LCD displays which are on sale for $8.00 each at www.flat-panel.com. Hope this helps Pherd (28 years ago, 12-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | config download problems
|
|
Hi I am building a handyboard from scratch after finding it on the net. I actually purchased two pcb's from Douglas Electronics. An aside, they were great to deal with answering all my questions promptly and efficiently. I built the first hb and had (...) (28 years ago, 12-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Source of 68HC11 in UK?
|
|
Does anyone know of a supplier for the 68HC11 in the UK? Also any handyboard suppliers in UK. Peter (28 years ago, 12-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Is my serial interface shot?
|
|
I get the message "Board disconnected or not responding" when I try to run ic. (The board was working fine before).So I tried to re load the pcode, but I have run into a slight problem: With the serial interface disconnected, I hold down the stop (...) (28 years ago, 11-Dec-98, to lugnet.robotics.handyboard)
|
