 | | Line follower kit
|
|
I was wondering if anybody had used the Line follower kit from the robotstore? Is it pretty much plug and play (besides a little programming) for the handyboard? Thanks. Dave (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: DC motor voltage source
|
|
Philip: I depends on how many motor driver ports you want to have on the new voltage. If you have just two motors, then lifting (and wirewrapping) pin 8 for one chip whould be enough. The motor outputs affected are nearest to the chip modified. I (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Voltage for the DC motor
|
|
Ja, I could not tell you for the life of me what 'type' f a HB it is, but I remember someone once telling me that you could just remove one of the pins from the driver chip instead. This method would be less final (ie, just bend the lead up and if (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: programming help.
|
|
The "<<" is a shift left operator in C 0E is the actual motor port on the Handy Board. (...) mean? (...) between 4 and 7. (...) peek(address) | value). I don't have any documentation here, so I don't know what is stored in 0x0e, but it could be the (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Bend/ Flex Sensor
|
|
I think its cheaper to get an old Nintendo power glove and Hack it! (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: IR Detection
|
|
Hi Most of the IR LED's sold at Radio Shack are the 840-880 nm wavelenght type. The Sharp tin can requires the 940 nm wavelength IR beam if my memory serves me right, it also requires to be modulated at 38 or 40 kHz depending on the model. This 38 (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | as11_ic
|
|
(...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Voltage for the DC motor
|
|
(...) Sorry, I cannot help you. My board look exactly like the one on the picture. It's a Handy Board v.1.2 I bought assembled from Glasson Research. Does somebody knows what board Phillip is using? -- Eric (26 years ago, 1-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | code segment
|
|
Hi all, I have writen a code, when i download it i received following message. "c:\ic\libs\speed.icb(1): Code and data segments collide -- overflow of 681 bytes" After that I reduced the size of code and downloaded it, It was successfull. I got (...) (26 years ago, 1-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Mailing List
|
|
I used to work at AOL technical support, I would be very much interested if you could figure out how to use AOL as a POP3, AOL is NOT a POP3 server. AOL is very proprietery, one of the many reasons (and doesn't support DUN - dial-up networking) that (...) (26 years ago, 1-Nov-98, to lugnet.robotics.handyboard)
|
