 | | Re: Other LCDs
|
|
Drew I picked up a 20x4 LCD from B. G. Micro (see their on-line catalog at (URL) and view page 2 - the LCD is the one in the upper right at $8.95, part number LCD1002). For 2x16, it will work just plugging into the HB. I poked memory locations (...) (28 years ago, 29-Oct-98, to lugnet.robotics.handyboard)
|
| |
| | HB woes
|
|
I'd appreciate mucho any help and ideas you all have I am building my HB, finally got the caps and crystal osc. working, and ran the HBDL program to download. All good and fine. I go off and solder in the transparent latch, and while doing so I (...) (28 years ago, 28-Oct-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Motor output
|
|
(...) The motor controls in the Handy Board library supports only 8 levels of power. Upgrade! Get the Smooth PWM version made by Julian Skidmore in the software contributed page on the Handy board web site ((URL) will have to do multiple things: 1- (...) (28 years ago, 28-Oct-98, to lugnet.robotics.handyboard)
|
| |
| | Motor output
|
|
Hi! When I work with the motor outputs, I found that the outputs are not linear. The "motor(m,p)" changes the output only in an increment 10 of p. Is there anyway I can get a more presiced output? Thanks. Keith (28 years ago, 28-Oct-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Implementation question
|
|
Hi All! I'm having exactly the same problem! The download seem to work correctly but after switching off and on the board again it seem not to start over. I have momentarily used another reset device. I dont know exactly the specification but it (...) (28 years ago, 28-Oct-98, to lugnet.robotics.handyboard)
|
