Subject:
|
HB woes
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 28 Oct 1998 22:20:14 GMT
|
Original-From:
|
Shiva Sinha <SINHA@WAM.UMDavoidspam.EDU>
|
Viewed:
|
1603 times
|
| |
| |
I'd appreciate mucho any help and ideas you all have
I am building my HB, finally got the caps and crystal osc. working, and
ran the HBDL program to download. All good and fine. I go off and solder
in the transparent latch, and while doing so I knock the board. I go back
and check that to see what problems I've created:
pin 26 gives +5volts
pin 5 gives me a 2MHz signal (about 700mV pp), and 2.8V
but -> pin 1 is giving me 2.85V && The Batt LED will not go off && I can
no longer get into bootstrap mode :(
Did I blow my 6811? What other things should I check? the only other stuff
I have installed is the memory chips
Thank you very much
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|