 | | Re: Steppers
|
|
Dear Terri, If the motors turn sparatically, that means the coils are probably not hooked up in the correct order. Try swapping them around and see if anything improves. The motors you are using are the bipolar type. There is a decent way of hooking (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Serial line interrupt
|
|
(...) to (...) about (...) Hi, you could simply build and Acknowledge routine so that every character sent by the PC could be echoed back by the HandyBoard. It asks a bit more of processing time from the HandyBoard, but at least it's simple to build (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
| |
| | Steppers
|
|
Hi. I was reading through a compilation of emails from the Handy Board Q&A and found a lot of great questions, but no answers to them. I am trying to power some steppers, microsteppers from the RobotStore catalog, with the HB and am not having much (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Serial line interrupt
|
|
(...) I had the same problem a few weeks ago, ended up writing an interrupt handler for the Handy Board which will buffer up the incoming serial information so that none of it is lost. I guess the Handy Board normally just polls the serial port (I (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
| |
| | using the MC34064 LVI
|
|
Hello, This is a warning for anyone considering using the Motorola MC34064 to replace the DS1233. I have just built a couple handyboards and I had some problems getting them working. I finally tracked the problem done to the LVI. I used the MC34064 (...) (28 years ago, 6-Jul-98, to lugnet.robotics.handyboard)
|
