 | | HOW TO UNSUBSCRIBE
|
|
This is the periodic unsubscribe message. To unsubscribe from the Handy Board list, please send mail to fredm@media.mit.edu He is the only one who can remove you from the list. That way, when you send mail to fredm@media.mit.edu you're not telling (...) (28 years ago, 30-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Simulation ?
|
|
Hi everyone .... i need help in simulation of the robot movement ,......... What program did u all use with HB by using 'IC' to write in the program....??? I need some ref. in this.........please help me ......... Regards, Linnar (28 years ago, 30-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Unsubscribe
|
|
Please unsubscribe Thanks Grady (28 years ago, 29-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Cirrus Servos - Question - How do they rate compared to Futaba
|
|
I have a Cirrus Cs-20 BB Sub-Micro Servo that I have been using for testing. I was wondering how this servo compares to others like Futuba and others. Since I know how this one behaves, I can use that info as a comparrison. What Futuba mode is (...) (28 years ago, 29-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (28 years ago, 29-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | RE: Walking Robot Question
|
|
Mike, I have mentioned before that I am going to use a Novasoft MSCC11 board with an HC811E2 (which has 8K EEPROM on board) and a piece of software called Robobug which uses all 16 of the i/o pins to control 16 servos. These servos are all (...) (28 years ago, 29-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Walking Robot Question
|
|
I'm wondering how the servos are controlled on a walking robot. I would imagine that multiple legs would have to be moved simultaneously and in sync with each other. If servos are changed one-at-a-time then one leg would be dragging the others. A (...) (28 years ago, 29-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Cirrus Servos - Question - How do they rate compared to Futaba
|
|
Try (URL) go to product info and then servos. Mike (...) I (...) (28 years ago, 29-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: microcontroller speeds
|
|
If they replace the controller on their board with a chip that is rated at 20MHz but they are still using the old board with its 16MHz oscillator won't it still run at 16MHz? ---...--- (...) (28 years ago, 28-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: micrcontroller speeds
|
|
Hi Replacing the 16MHz version with the 20 Mhz CPU would affect only the timer speed of the internal timers. We are using the MC and MD versoon of the 196. Connected to those timers are about the following : -PWM 1 & 2 -Wavegenerator (if it has one) (...) (28 years ago, 28-Jun-98, to lugnet.robotics.handyboard)
|
