 | | Re: motors
|
| For servo, there is a certain threshold duty cycle (say 50%) of the PWM signal, where anything above this threshold will make it to run forward, and less will make it to run backward. So, you still need to apply the PWM even if the servo is not (...) (28 years ago, 6-Jun-98, to lugnet.robotics.handyboard)
| | | | | Re: LCD Removal
|
| Hello, Does anyone know if the Rug Warior Pcode run without the LCD? (Pcoderwl.S19) If not : 1 is there another RW pcode that will run without the LCD? I using the RW pcode on my Fingerboard II with out the LCD and I think this may be an issue. (...) (28 years ago, 6-Jun-98, to lugnet.robotics.handyboard)
| | | | | motors
|
| That did answer my question. I am not familiar with servo motors, I have only used plain DC motors. I am also familiar with PWM. I was just unable to determine if the same PWM signal that drives plain DC motors could also drive servo motors. From (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)
| | | | | Re: LCD Removal
|
| it's easy: just use the replacement pcode_hb.s19 file provided by Kent Farnsworth: (URL) your message you said: (...) and still have the HB work. My design does not require the LCD, so if i could r emove it my robot would then be a little more (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)
| | | | | Re: Lego motors
|
| (...) As I've said, I think the new Lego Technic gear motors are a great deal. They're inexpensive (about $18 each), they seem to be quite efficient, and they run well directly from the HB power supply. If you're building your robot out of Legos (...) (28 years ago, 5-Jun-98, to lugnet.robotics.handyboard)
|
|
