 | | Re: please unsubscribe me
|
|
---...--- (...) (28 years ago, 26-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: unsubscribe
|
|
---...--- (...) (28 years ago, 26-May-98, to lugnet.robotics.handyboard)
|
| |
| | Which R4 should I use???
|
|
I notice that in hbmanual.pdf there is a different value for R4 than in hba.pdf since I used the list of hbmanual, I bought R4=2.94k precision resistor, but in the asembly file it says 3.83k precision resistor. Which one is the good one and why need (...) (28 years ago, 26-May-98, to lugnet.robotics.handyboard)
|
| |
| | Pyroelectric Sensor
|
|
Hello. I have working with a handyboard, and I am trying to obtain information on how to properly use a eltec 442-3 pyroelectric sensor. I bought a complete one with a lens. My objective is for my lego robot to locate either a flame or heat source, (...) (28 years ago, 26-May-98, to lugnet.robotics.handyboard)
|
| |
| | Legos
|
|
Does anyone have any experience with any of the Lego technic systems. I am looking for a car/truck that has motors (or can add motors to), has enough room for a handyboard, and has the rack and pinion steering. I would also need a servo for the (...) (28 years ago, 25-May-98, to lugnet.robotics.handyboard)
|
| |
| | HOW TO UNSUBSCRIBE
|
|
Greetings, This is the periodic friendly reminder that in order to unsubscribe, you must send an email to fredm@media.mit.edu asking thusly. Again, the method for unsubscribing is: 1. write an email saying "please unsubscribe me"; 2. send it to (...) (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | Distance Measuring Sensor
|
|
Hi ! How is it possible to interface one or more SHARP GP2D02 to the HANDYBOARD ?? Best Rerards Diego (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | Pad sizes and hole sizes
|
|
I'm working on a board and I would like to avoid much trial and error. I have read much on selection of pad sizes/via sizes and hole sizes but there seems to be some contridiction. Does anyone know what the pad sizes (for ICs), hole sizes (for ICs) (...) (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
