 | | Legos
|
|
Does anyone have any experience with any of the Lego technic systems. I am looking for a car/truck that has motors (or can add motors to), has enough room for a handyboard, and has the rack and pinion steering. I would also need a servo for the (...) (26 years ago, 25-May-98, to lugnet.robotics.handyboard)
|
| |
| | HOW TO UNSUBSCRIBE
|
|
Greetings, This is the periodic friendly reminder that in order to unsubscribe, you must send an email to fredm@media.mit.edu asking thusly. Again, the method for unsubscribing is: 1. write an email saying "please unsubscribe me"; 2. send it to (...) (26 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | Distance Measuring Sensor
|
|
Hi ! How is it possible to interface one or more SHARP GP2D02 to the HANDYBOARD ?? Best Rerards Diego (26 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (26 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | Pad sizes and hole sizes
|
|
I'm working on a board and I would like to avoid much trial and error. I have read much on selection of pad sizes/via sizes and hole sizes but there seems to be some contridiction. Does anyone know what the pad sizes (for ICs), hole sizes (for ICs) (...) (26 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (26 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (26 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Board not responding
|
|
(...) The most probable cause of this is a dead 6811. (it spoils rather easily... :(Because everytime i have a problem with the board, it turns out to be nothing more than a shot 6811. Even replacing the 7805 with a LM2931T kills it. (26 years ago, 23-May-98, to lugnet.robotics.handyboard)
|
| |
| | Board not responding
|
|
Hi! The handy board was working good before and I haven't used the board for a while. Recently, I ran the downloader few times, but I couldn't download the bootstrap. I think the download mode is ready, but the error message like "Board not (...) (26 years ago, 23-May-98, to lugnet.robotics.handyboard)
|
| |
| | setting the best PWM frequency for DC motor
|
|
hello everyone, I found some information on "How do I set best PWM parameters for DC motors?" from the "Robotics Information" homepage, (URL) inside it described that in order to make current to flow steadily in between pulses, you need to satisfy (...) (26 years ago, 23-May-98, to lugnet.robotics.handyboard)
|
