 | | HOW TO UNSUBSCRIBE
|
|
Greetings, This is the periodic friendly reminder that in order to unsubscribe, you must send an email to fredm@media.mit.edu asking thusly. Again, the method for unsubscribing is: 1. write an email saying "please unsubscribe me"; 2. send it to (...) (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | Distance Measuring Sensor
|
|
Hi ! How is it possible to interface one or more SHARP GP2D02 to the HANDYBOARD ?? Best Rerards Diego (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | Pad sizes and hole sizes
|
|
I'm working on a board and I would like to avoid much trial and error. I have read much on selection of pad sizes/via sizes and hole sizes but there seems to be some contridiction. Does anyone know what the pad sizes (for ICs), hole sizes (for ICs) (...) (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
unsubscribe (28 years ago, 24-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Board not responding
|
|
(...) The most probable cause of this is a dead 6811. (it spoils rather easily... :(Because everytime i have a problem with the board, it turns out to be nothing more than a shot 6811. Even replacing the 7805 with a LM2931T kills it. (28 years ago, 23-May-98, to lugnet.robotics.handyboard)
|
| |
| | Board not responding
|
|
Hi! The handy board was working good before and I haven't used the board for a while. Recently, I ran the downloader few times, but I couldn't download the bootstrap. I think the download mode is ready, but the error message like "Board not (...) (28 years ago, 23-May-98, to lugnet.robotics.handyboard)
|
| |
| | setting the best PWM frequency for DC motor
|
|
hello everyone, I found some information on "How do I set best PWM parameters for DC motors?" from the "Robotics Information" homepage, (URL) inside it described that in order to make current to flow steadily in between pulses, you need to satisfy (...) (28 years ago, 23-May-98, to lugnet.robotics.handyboard)
|
| |
| | Where can I find spec. of the LM052L
|
|
I have an equivalent LCD screen (sharp L16255), I think, but it is a bit different from the LM052L and I am not sure how to interface it to the handy board. I cannot find any spec. on neither of these LCD screen and just need a hint maybe. Thanks (...) (28 years ago, 22-May-98, to lugnet.robotics.handyboard)
|
