| | Re: RC Servo motor internal electronics
|
|
Ideally, I could use an H-bridge on the same board as the "new" electronics and provide expanded feedback such as current sensing or encoder in addition to the normal servo interface. It would also be nice to allow PWM to control the power presented (...) (26 years ago, 19-May-98, to lugnet.robotics.handyboard)
|
|
| | Handyboard questions
|
|
Has anyone used the eltec 442-3 pyrometer with the Handyboard?? I am in the process of using legos to build a robot, and have a completed 442-3 pyrometer with the lens and all that I got in. I am looking for the best way to wire this sensor, and I (...) (26 years ago, 18-May-98, to lugnet.robotics.handyboard)
|
|
| | Re: Harddisk-Crash - HELP
|
|
(...) The Handy Board web site has a mail list archive page, from which you can download archives of past postings. The last item on the list is entitled "Jan 1997 -- present" (which means it's probably huge). Good luck. --Will , , __@_/ \_@__ |/ | (...) (26 years ago, 18-May-98, to lugnet.robotics.handyboard)
|
|
| | Re: Pad/Hole Widths
|
|
Thanks, I was going to use a pad/hole size of .050/.028. The default size of my library uses .050/.025. I checked some pin size data and it shows .015 (min) to .023 (max). Allowing .008 to .010 extra and .003 for plating, it seems that the best size (...) (26 years ago, 18-May-98, to lugnet.robotics.handyboard)
|
|
| | Harddisk-Crash - HELP
|
|
Hi all, during a harddiskcrash on my computer, i lost all my handyboard mailings. I the past i had contact with view german people but i haven´t any mail-adresses. Please contact me again !!!!! Bye Bernd Klein ;-) P.S. Is there a way to get all (...) (26 years ago, 18-May-98, to lugnet.robotics.handyboard)
|