| | Re: Handy Board problem
|
|
I got mine from FutureActive. I don't remember what the cost was and I don't remember what else I got from them, but it was more than just that. I think I placed about 2 orders with them. I would much rather deal with Mouser and Digikey. If you have (...) (26 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
|
| | Re: LCD Addressing - & - Expanded Mode
|
|
I found the driver you sent earlier. Thanks. BTW, I found out that my LCD is good but I still have a problem. It appears that I cannot change my CONFIG reg. Maybe because it is an 811E2; don't know. Should be able to however. Since the program was (...) (26 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
|
| | Re: LCD Addressing - & - Expanded Mode
|
|
Wierd: Anyway I have some kind of problem with the handyboard. All steps up to the testing of the LCD went fine. When I plugged in the LCD and turned it on, it lights up (one line) bright not dim. I tried to download the pcode_hb.s19 with config set (...) (26 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
|
| | Re: LCD Addressing - & - Expanded Mode
|
|
So, this still doesn't help me figure out how to address the LCD. It has A8 and A9 connected along with a CLK from Port A. Does this mean that the LCD is NOT memory mapped? Do I first have to write to Port B then write to Port A, to clock it. This (...) (26 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
|
| | Re: DS1233 Monitor Chip
|
|
(...) I use an MC34064 on a 68hc11, and have never had any problem with it. Philippe Guermeur guermeur@ensta.fr (26 years ago, 4-May-98, to lugnet.robotics.handyboard)
|