 | | Re: LCD Addressing - & - Expanded Mode
|
|
I found the driver you sent earlier. Thanks. BTW, I found out that my LCD is good but I still have a problem. It appears that I cannot change my CONFIG reg. Maybe because it is an 811E2; don't know. Should be able to however. Since the program was (...) (28 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: LCD Addressing - & - Expanded Mode
|
|
Wierd: Anyway I have some kind of problem with the handyboard. All steps up to the testing of the LCD went fine. When I plugged in the LCD and turned it on, it lights up (one line) bright not dim. I tried to download the pcode_hb.s19 with config set (...) (28 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: LCD Addressing - & - Expanded Mode
|
|
So, this still doesn't help me figure out how to address the LCD. It has A8 and A9 connected along with a CLK from Port A. Does this mean that the LCD is NOT memory mapped? Do I first have to write to Port B then write to Port A, to clock it. This (...) (28 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: DS1233 Monitor Chip
|
|
(...) I use an MC34064 on a 68hc11, and have never had any problem with it. Philippe Guermeur guermeur@ensta.fr (28 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
| |
| | Micromouse speed
|
|
Hi, does anyone know how fast should a micromouse move? and the other question is, will the 6811/handyboard have enough capability (address space) for maze solving? If not, what should I need? extra memory or 32bits processor? Thank you for any (...) (28 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
