 | | Re: re-download problem
|
|
Hold down the START button while powering on. This will prevent the board from running main(). Fred In your message you said: (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo Routines
|
|
When I see the servo chatter, the knob is returning the same value. In fact I can just set a constant unchanging value without using the knob and get the chatter. I've tried this on two HB's and get the same results. The servos are small Futabas. (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo Routines
|
|
can you ascertain whether the knob is returning the same value every time through the loop? i wasn't clear if "even when the knob is not changing" meant just that you weren't turning the knob, or whether you were sure it was always producing the (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
| |
| | re-download problem
|
|
I forgot to unload the program that I was running on my handyboard before I quit out of ic. and it won't let me putting the board on bootstrap mode. as soon as I power up the board, it starts running the last program. can anyone tell me how to clear (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
| |
| | Servo Routines
|
|
Question. I've been playin with the servo routines available from the HB page. One thing I've noticed. The servo's seem to chatter a lot. Is this normal. A routine that does nothing but loop, read the knob and output a value based on the knob to the (...) (26 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
