Subject:
|
Re: Servo Routines
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 13 Apr 1998 18:43:49 GMT
|
Original-From:
|
Fred G. Martin <FREDM@MEDIAspamless.MIT.EDU>
|
Viewed:
|
1532 times
|
| |
|
|
can you ascertain whether the knob is returning the same value every
time through the loop? i wasn't clear if "even when the knob is not
changing" meant just that you weren't turning the knob, or whether you
were sure it was always producing the same value.
fred
In your message you said:
> Question. I've been playin with the servo routines available from the HB
> page. One thing I've noticed. The servo's seem to chatter a lot. Is this
> normal. A routine that does nothing but loop, read the knob and output a
> value based on the knob to the sevo works well but the servos chatter.
> Even when the knob is not changing the servo is not still. There are no
> other routines running. Just the IC3.2 stuff with this short loop.
>
>
> Bruce A. Moore
>
|
|
Message is in Reply To:
 | | Servo Routines
|
| Question. I've been playin with the servo routines available from the HB page. One thing I've noticed. The servo's seem to chatter a lot. Is this normal. A routine that does nothing but loop, read the knob and output a value based on the knob to the (...) (27 years ago, 13-Apr-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
