| | Hall Effect
|
|
Does any one know of a source for Hall Effect sensors? I know DigiKey sells them, but I just want to buy a few. I don't want enough stuff to get me upto the $25.00 minimum order. I have not been able to find them in Mousers catalog. Can anyone (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
|
| | New use for the HB
|
|
Just thought I'd write a little note to everyone describing how we are using the HB. I've been working with Bloomington High School South in Bloomington, IN. About a year ago they decided to put together a Solar Bike Team to race in the SunRayce in (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
|
| | Re: 68HC811E2
|
|
... but I tryed this already and without success. The hbdl loader says "Invalid CONFIG reg (0xFF) Try again" and when I check the eeprom area with PCBUG11, it is already there. I think, the E2 has a special protection for the CONFIG ---...--- Hello (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
|
| | Trouble with a dalla memory .
|
|
I have assembly a handyboard the last week , and somethings is wromg, and i can find what is the problem. This board have a dallas backed memory , so i dont use the battery pack. The memory can be removed and put in the place a common memory (don't (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
|
| | Re: 68HC811E2 Can't be set
|
|
I had the same problem with an A1, in this case it was stuck at 0x0D. hbdl would NOT set the config, but I was able to do it with dl from Win95 run in full MS-DOS mode. Even this was problematical; dl would invariably hang the computer once or (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|