Subject:
|
Re: 68HC811E2 Can't be set
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 2 Apr 1998 15:33:01 GMT
|
Original-From:
|
Brett Anthony <anthonyb@ecs.csus.edu/stopspammers/>
|
Viewed:
|
1114 times
|
| |
|
|
I had the same problem with an A1, in this case it was stuck at 0x0D. hbdl
would NOT set the config, but I was able to do it with dl from Win95 run in
full MS-DOS mode. Even this was problematical; dl would invariably hang the
computer once or twice, necessitating a complete reboot, but eventually it
worked, and I only had to make it work once. Note that dl won't work with
the E2, you'll have to try dlm. See the HB Tech Reference Section 4.3
Brett Anthony
Research Technician
School of Engineering and Computer Science
California State University, Sacramento
e-mail: anthonyb@ecs.csus.edu
phone: (916)278-6253
fax: (916)278-5949
address: Brett Anthony
E&CS, CSUS
6000 J St
Sacramento CA 95819-6023
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
