|
| | Re: 68HC811E2
|
| Thanks Clancy, but I tryed this already and without success. The hbdl loader says "Invalid CONFIG reg (0xFF) Try again" and when I check the eeprom area with PCBUG11, it is already there. I think, the E2 has a special protection for the CONFIG reg. (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| | | | Re: 68HC811E2 Can't be set
|
| No I can't believe that the config register is unchangeable, because I own a single 68hc811e2 that has a correct config, but 12 others that dont, also these are used in the miniboard pre handyboard? with a config set at 0d, if i remember my old (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| | | | Re: 68HC811E2
|
| (...) My advice, don't waste your time, i spent about a year trying to figure that out and never got the config register changed to anything useful, and I also contacted motorola about 5 times and no tech person there could get it changed either. (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| | | | Re: 68HC811E2
|
| -----Original Message----- From: E. Baeck <erwin.baeck@styria.com> To: Handy Board Mailinglist <handyboard@media.mit.edu> Date: Wednesday, April 01, 1998 10:50 AM Subject: 68HC811E2 (...) sounds like my chip. Is your config Register stuck at 0xFF (...) (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| | | | Re: Working with a different compiler
|
| Jaron, Does the compiler provide LCD driver for HB or you ported the code to this compiler ? -Pandit (27 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| |