Subject:
|
Re: 68HC811E2 Can't be set
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 2 Apr 1998 06:07:22 GMT
|
Original-From:
|
HobbyTec <hobbytec@cas.STOPSPAMauracom.com>
|
Viewed:
|
1090 times
|
| |
|
|
No I can't believe that the config register is unchangeable, because I own a
single 68hc811e2 that has a correct config, but 12 others that dont, also
these are used in the miniboard pre handyboard? with a config set at 0d, if
i remember my old board settings. There must be a way to set these chips,
does anyone here have a miniboard or know how to set these other mcu's,??
what is so different about this chip than the a1 that its such a pain to use
the 103f register??
thanks,
Quinn Marshal
-----Original Message-----
From: E. Baeck <erwin.baeck@styria.com>
To: Virtual <deicide@lightspeed.net>
Cc: handyboard@media.mit.edu <handyboard@media.mit.edu>
Date: Wednesday, April 01, 1998 9:52 PM
Subject: Re: 68HC811E2
> Thanks John,
>
> but I can't believe that, it must be a way there, to alter the CONFIG • register !
>
> Erwin
>
> Virtual wrote:
>
> > > sounds like my chip.
> > > Is your config Register stuck at 0xFF like mine is?
> > > then entire 103f register is all FF, this is how it came from motorola • when
> > > I ordered it. and I cant seem to get it to do anything other than boot • with
> > > pcbug, but without a 0c config its no good for the handyboards/rug, how • do u
> > > set this thing??
> > >
> > > thanks,
> > >
> > > Quinn Marshal
> >
> > My advice, don't waste your time, i spent about a year trying to figure • that out
> > and never got the config register changed to anything useful, and I also
> > contacted motorola about 5 times and no tech person there could get it • changed
> > either. Spend the money on the A0 or A1, or call motorola and request a • few :)
> >
> > John
>
>
>
>
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
