|
|
 | | (no subject)
|
| Hey Chuck, Being the lazy person that I am I modified another servo instead of figuring out the problem w/ the other one(I'll check it out later...) THE PROBLEM IS SOLVED!!!!!!! They both run much closer in speed. Now I'm off to get the rest of the (...) (27 years ago, 9-Aug-97, to lugnet.robotics.handyboard)
| | | | | Magnetic card readers
|
| Thanks for don't replly to none of my e-mail!!! All it's cool , but i can accept nobody know wath i answer??? Well i really want somebody tell me: "well i don't want to reply you" . I can do work the reader with code in c , and i want to know how i (...) (27 years ago, 9-Aug-97, to lugnet.robotics.handyboard)
| | | | | Re: Servo as drive motor
|
| (...) Because the servos are closed systems they don't have a hard requirement that their motors run at the same speed, however it would affect the slew rate which is spec'd so they have to be reasonably close. If you zapped the capacitor and turned (...) (27 years ago, 8-Aug-97, to lugnet.robotics.handyboard)
| | | | | stepper motors
|
| Hi, Thanks for all the responses regarding CdS photo cells. Now I am considering using stepper motors in my project as well. I have seen some postings on this list before regarding these motors. Can anyone point me in the right direction for (...) (27 years ago, 8-Aug-97, to lugnet.robotics.handyboard)
| | | | | Re: Servo as drive motor
|
| (...) I'll try to replace the caps and see if there is an improvement. I was thinking that when I melted the new leads to the motor I may have left the iron on it for too long, thus burning up the caps. I'm going over to my dad's shop to work on (...) (27 years ago, 8-Aug-97, to lugnet.robotics.handyboard)
|
|
