 | | FW: Obtaining the Handyboard in the UK
|
|
I don't know if Patrick sent this to the list but just in case here is his mail regarding the Handyboard in the UK. (...) (27 years ago, 22-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Obtaining the Handyboard in the UK
|
|
<bold>John Hatton, writes: </bold><x-quoted>The problem with ordering from the USA is that</x-quoted> <x-quoted>customs charge taxes/duty on goods over ?145 ($237 approx.) which</x-quoted> <x-quoted>increases the cost. </x-quoted> In Canada custom (...) (27 years ago, 22-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Obtaining the Handyboard in the UK
|
|
Does anybody know if it is possible to get the Handyboard in kit form or assembled in the UK. The problem with ordering from the USA is that customs charge taxes/duty on goods over ?145 ($237 approx.) which increases the cost. Thanks in advance for (...) (27 years ago, 22-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: LM34 temp sensor to handy board?
|
|
(...) Depends on the specific version of the LM34, I believe mine can read between -50 to 300 degrees Fahrenheit. ---...--- Jeff Keyzer UCSD EE Major jkeyzer@ucsd.edu (URL) (27 years ago, 22-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: LM34 temp sensor to handy board?
|
|
(...) of (...) accuracy. What is the maximum temperature that the LM34 will 'read' ? Thanks Chris (27 years ago, 22-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: LM34 temp sensor to handy board?
|
|
Jeff, I used a couple of the 10mV/deg Kelvin ones, with nothing more than the current load resistor, ie no amplification at all. For example, freezing point = zero celcius = 273 Kelvin = 2.73 volts. With the 6811 resolution of about 20 mV (5v / (...) (27 years ago, 22-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | headers
|
|
This may sound like a dumb question, but I don't know where to get headers. Digi Key has some but 4 different kinds. The parts list says nothing except 14 pin female header. Nothing else. Where did you get your headers and what are the part numbers? (27 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo control using Miniboard slaved
|
|
Chuck: I agree with you; what I've done with the MiniSSC is to break the path into a set of linear segments with via points in joint space. The lynxmotion arm ends up needing a lot of points (therefore moving pretty slowly) to avoid jerkiness, but (...) (27 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: LCD display
|
|
(27 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: LCD display
|
|
Hi. Give me the location and phone number to this place that you can order them and I will consider ordering several and selling them off individually. Scott sherman@plains.nodak.edu CSG ITS NDSU (...) (27 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
