|
|
 | | Driving large motors with the Handyboard
|
| Hi. I'm kinda new at this. I was wondering if anyone can help me answer this question. If I wish to drive large motors with a Handyboard, I understand that I have to use an h-bridge. Will I need to know anything about PWM before attempting this (...) (29 years ago, 23-Mar-96, to lugnet.robotics.handyboard)
| | | | | Re: Resets
|
| I have a few suggestions, these are all things that I have seen before to help reduce noise from motors I think that the problem might be due to crap getting back to the power line... thereby causing the DS1233 to say, time to reset... - try a (...) (29 years ago, 23-Mar-96, to lugnet.robotics.handyboard)
| | | | | OC2 and OC3 outputs?
|
| Where on the v1.2 board do I tie into the OC2, OC3, and OC4 output lines? Is there a schematic which has all the I/O pins labeled? I need to use the OC lines to output pulse trains. Does the library software use these ports for the motor() commands? (...) (29 years ago, 23-Mar-96, to lugnet.robotics.handyboard)
| | | | | Re: Resets
|
| (...) I can't say that I have an explanation of why the motors would work at first and then cause problems later, but I can say that: Not all motors work with the Handy Board. In particular, motors that want to draw too much current (e.g., more than (...) (29 years ago, 22-Mar-96, to lugnet.robotics.handyboard)
| | | | | Analog semsor inputs.
|
| What is the range of detection of the analog sensors? Are there discreet detection levels that the hendyboard can recognize? (29 years ago, 22-Mar-96, to lugnet.robotics.handyboard)
|
|
