Subject:
|
OC2 and OC3 outputs?
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 23 Mar 1996 18:45:32 GMT
|
Original-From:
|
Mike Ross <mross@%AvoidSpam%outland.jsc.nasa.gov>
|
Viewed:
|
1992 times
|
| |
|
|
Where on the v1.2 board do I tie into the OC2, OC3, and OC4 output lines?
Is there a schematic which has all the I/O pins labeled? I need to use
the OC lines to output pulse trains. Does the library software use
these ports for the motor() commands? I don't need the L293 drivers for
my current application, just the OC and IC lines. Thanks.
-mike
* Michael L. Ross/C33 | Lockheed Engineering & Sciences Co.****
* Robotics Department | 2400 Nasa Rd. 1, Houston, TX 77058*****
*(713)333-7094 voice,(713)333-6071 fax*#include <disclaimer.h>*
* Finger me for my public key. mross@outland.jsc.nasa.gov ****
* If you weren't a socialist in your twenties, you had no heart.
* If you weren't a conservative by your thirties, you have no brain.
|
|
Message has 1 Reply:
 | | Re: OC2 and OC3 outputs?
|
| Take a look at the schematics, which are linked from the top page of the Handy Board web site. The info you are looking for is in the CPU / memory schematic. For the DC Motor outputs, the board uses a separate output latch---not the timer outputs. (...) (29 years ago, 24-Mar-96, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
