| | Re: To HB or not to HB, that is the question.
|
|
(...) I emailed the people at Imagecraft and asked them if ICC11 works with the handy board and they said they are working with Fred Martin on it. I noticed on thier home page that they claim to have LCD driver code in a library of version 4 ICC11. (...) (27 years ago, 24-Apr-97, to lugnet.robotics.handyboard)
|
|
| | Re: LCD & serial connection
|
|
It is possible you have a bum 6811. I have seen 6811's with bad output address lines. this causes mirroring in the RAM as what should be multiple locations get mapped to the same byte in memory. The downloader thinks things are working because each (...) (27 years ago, 24-Apr-97, to lugnet.robotics.handyboard)
|
|
| | LCD & serial connection
|
|
Thanks to those of you who sent your suggestions regarding the message below. I tried it all (replacing the LCD, checking each pin on both the RAM and the octal transparent latch 74HC373 for continuity, double checking the installed parts, I even (...) (27 years ago, 24-Apr-97, to lugnet.robotics.handyboard)
|
|
| | Re: More Power
|
|
Since we're on the topic, I would vote for the Hitachi SH series of 32-bit RISC microcontrollers. For $99, you can get an evaluation board with 64K of RAM (with sockets for up to 256K and other provision for further expansion), and the full GNU (...) (27 years ago, 23-Apr-97, to lugnet.robotics.handyboard)
|
|
| | Re: motors
|
|
Here's the motor I used so you all know not to buy it. Barber-Coleman FYQF 63310-9 12V DC If anyone has had any experience with this one or its siblings, please share your thoughts. I would be grateful for any further info. :) ---...--- ericson mar (...) (27 years ago, 23-Apr-97, to lugnet.robotics.handyboard)
|