 | | Re: IR Collision avoidance
|
|
(...) I have a few questions for you. How did you combine the 38khz and 500hz signal. In a design that I am working on now I have two signals similar to yours and an enable signal running into a three input AND gate. I haven't built it yet but it (...) (28 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | motors
|
|
Hi, Yes, that schematic posted by Prabal was exactly what I meant. I sent you the bmp anyway, Adam. David (28 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Re: motor voltages
|
|
Adam, I think David meant something like this: |---|<|---|<|---|<|---| M+ ----x x----(motor)---- |---|>|---|>|---|>|---| | | M- ---...--- That way you have a voltage drop AND conduction in both directions. - Prabal (...) (28 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | where to get a board.
|
|
hello. i'm new to this mailing list, and would like to purchase a handy board. i'm curious if there i a place where i could perhaps find a used one (in working order), or who the best (read: cheapest) distributor is. thanks for info you can provide. (...) (28 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Servos and Handyboard.
|
|
you can't power 2 servos from the hb's own +5v supply. get a separate 5v supply (linear regulated, *noT* a switching supply, OR batteries) and run your servo power from that. connect this external supply ground to the HB motor ground (on J13). -Fred (...) (28 years ago, 2-Mar-97, to lugnet.robotics.handyboard)
|
