|
|
 | | Is 18V correct?
|
| Oh, you hardware guys must really hate us software guys but... I just purchased a volt meter, I had used on in college a long time ago, so I placed the voltmeter across the AC adapter and it read 18.0, I'm guessing this is 18 volts, but I could be (...) (28 years ago, 29-Jan-97, to lugnet.robotics.handyboard)
| | | | | Re: Rug Warrior Program
|
| (...) [snip] (...) Well, you say that, but you got this far, didn't you? port_a should be 0x1000, port_d should be 0x1008, declared as int. These are the hardware addresses of those ports on the HC11. Did you get a copy of all the Handyboard (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
| | | | | Re: 68HC11
|
| JTW, I have ordered from a company in Dallas, TX called B.G.Micro, inc.. They have the 68HC11A1FN for $6.95 and the socket for it. Check out their web page: (URL) Orders only - 1-800-276-2206 Tech support 972-271-9834. I have run across other (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
| | | | | Rug Warrior Program
|
| I have entered all the rug warrior program and have got it all debugged of all but two errors. By debugged I mean I have found all the mistakes that I made when entering it and got all but two error messages to go away when I attempt to load it into (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
| | | | | Re: High power motor drivers
|
| Keith Check the HB home page. Fred posted my info for a H-bridge that will handle two 12V-55V motors at 3A each. I know it's not exactly a custom bridge, but you can make the PCB from scratch. The LMD18200 from National makes this really easy. (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
|
|
