|
|
 | | dual servos
|
| Hello world, To richardv@abac.com, I am eagerly awaiting your results. To joe.doubek@privy.com, I'll keep you posted. So far I have gotten to the stage of pretty well ruling out input noise as the cause of twitching servos. I have almost identical (...) (28 years ago, 17-Jan-97, to lugnet.robotics.handyboard)
| | | | | Re: dual servos
|
| I'm a newbie at this, but I just read yesterday on a web page that servos want a signal (20 ms = ?? degrees) every 50 milliseconds or so, and if you stop sending the signal, they "go limp" and don't "hold" position tightly, but are deenergized and (...) (28 years ago, 17-Jan-97, to lugnet.robotics.handyboard)
| | | | | capacitor question
|
| I was just wondering about this - are you supposed to heatsink capacitors when soldering? My gut feeling says "no", except that my ECE TA seems to disagree. Any thoughts on this? (Sorry, this doesn't have too much to do with the handy board - (...) (28 years ago, 16-Jan-97, to lugnet.robotics.handyboard)
| | | | | Re: power and servo
|
| [problem 1: voltage on motor chips when no motor voltage applied] This is normal, because the motor chip INPUTS have +5v signals on them. These signals "bleed" into the motor chip power supplies. This isn't dangerous, but it isn't particularly good (...) (28 years ago, 16-Jan-97, to lugnet.robotics.handyboard)
| | | | | IR Demodulator
|
| Hello Everyone, I have had absolutely no luck in getting a IR Demodulator for my HB. I have tried every source given on this sight and even more. Can anyone help me to locate this part? Sharp (IS1U60) Having No Luck! Bill Rose (28 years ago, 16-Jan-97, to lugnet.robotics.handyboard)
|
|
