| | (# of sensors)
|
|
Can anyone tell me if it's possible to run more than one servo off the Handy Board? My design group and I are building a robot that will perform an autonomous search routine. We're in the rough developement stage and really trying to pin down just (...) (28 years ago, 7-Jan-97, to lugnet.robotics.handyboard)
|
|
| | Re: I think I fried my board!!
|
|
keith-- you might have fried the motor ground to logic ground connection. a couple of times in my lab using 6.270 boards people shorted motor high to logic ground, with the result being a vaporized trace between the two grounds (the inductor was not (...) (28 years ago, 7-Jan-97, to lugnet.robotics.handyboard)
|
|
| | Re: I think I fried my board!!
|
|
Yes it is probably the inductor. It acts as a fuse in many situations. You are lucky -- it could have been much worse. -Fred In your message you said: (...) (28 years ago, 7-Jan-97, to lugnet.robotics.handyboard)
|
|
| | HB - fast sensor reading
|
|
Hello, I have a clock signal of 5 kHz and an analog signal. (There are in total 128 clock pulses) I need to read in the analog signal every time the clock signal is high. So I need to read the clock signal with at least 10 kHz. I tried this with IC, (...) (28 years ago, 7-Jan-97, to lugnet.robotics.handyboard)
|
|
| | Re: I think I fried my board!!
|
|
Keith, We'd be happy to send you a new inductor to try out. Let us know how it works out. Best of luck! (...) - Prabal (28 years ago, 7-Jan-97, to lugnet.robotics.handyboard)
|