|
|
 | | Handy board parts
|
| I am searching for HB parts such as the 32K static CMOS ram p/n 62256-100LP, voltage monitor, p/n DS1233-10, IR demodulator p/n IS1U60, motor driver p/n L293, RS232 converter p/n MAX232CPE, or any acceptable substitutes. Would appreciate anyone (...) (28 years ago, 17-Dec-96, to lugnet.robotics.handyboard)
| | | | | Good Times virus warning!
|
| Sorry, I can't help myself. I have a 102 deg fever right now and I am not thinking straight. -Fred ------- Forwarded Message <<Subject: Final warning about the "Good Times" virus>> READ THIS: Goodtimes will re-write your hard drive. Not only that, (...) (28 years ago, 16-Dec-96, to lugnet.robotics.handyboard)
| | | | | steppers - HB
|
| Wondering if anyone knows of a good way to interface a couple of steppers to the HB AND if there are any ic routines written to control steppers. Ideas, comments, suggestions, questions welcome. Bruce (28 years ago, 16-Dec-96, to lugnet.robotics.handyboard)
| | | | | Sonar and encoder conflict.
|
| I am attempting to run the following routine on my Handyboard int check() { int inches; ping(0); msleep(35L); inches=sonar_time/150; printf("%d \n",inches); return inches; } The program runs great and returns the proper value (Thanks to the software (...) (28 years ago, 15-Dec-96, to lugnet.robotics.handyboard)
| | | | | Re: Polaroid Sensors
|
| The HB power source will work. Plug the power lines into the +5v and GND anywhere on the HB's headers. (...) (28 years ago, 14-Dec-96, to lugnet.robotics.handyboard)
|
|
