Subject:
|
Re: Sanscript & Spirit.OCX
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 11 Jan 2000 13:05:01 GMT
|
Original-From:
|
Marco C. <marco@soporcel.pt&StopSpammers&>
|
Viewed:
|
793 times
|
| |
|
|
At 19:53 10-01-2000 -0600, Rich Thompson wrote:
> How did you import the Spirit OCX into Sanscript?
I registered Spirit.OCX on my system (simply install the LEGO software).
Then inside Sanscript, I used the File | OLE/COM Wizard... option, clicked
the BROWSE button, navigated to the folder where the spirit.ocx file is,
forced the "*.ocx" mask so I could see it in the "Encapsulate Type Library"
form, clicked on Spirit.ocx file, pressed the OPEN button, et voila' :) A
new Sanscript cabinet (SPIRITLib) was created with an "image" of the Spirit
API.
:)
____________________
Marco C. aka McViper
|
|
Message has 1 Reply:
 | | RE: Sanscript & Spirit.OCX
|
| hmmm...I tried using the OLE/COM wizard last night, but kept getting an error message. Spirit.OCX is installed properly on the PC, but I did not force the *.ocx in the Encapsulate Type Library form. I will give that a go tonight. Thanks! Rich (...) (25 years ago, 11-Jan-00, to lugnet.robotics)
|
Message is in Reply To:
| | Sanscript & Spirit.OCX
|
| After reading the Jose Solorzano's (and Jake VanNoy's) thread about the possible use of Northwoods Software's Sanscript for pBrick control through Spirit.OCX, I've downloaded it (the Demo too) and tried Sanscript PRO (www.trulyvisual.com). It's a (...) (25 years ago, 10-Jan-00, to lugnet.robotics)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
