Robotics : 9667


Robotics / 9667	9666 \| 9668

Subject:	Re: Has anyone disassembled a 9v Train Motor?
Newsgroups:	lugnet.trains, lugnet.robotics
Date:	Mon, 3 Jan 2000 07:03:48 GMT
Viewed:	124 times

Ben Jackson wrote: > Has anyone investigated the possibility of disconnecting the motor from the > pickups on the wheels so it can be powered from the top plate without driving > other trains on the same track? Ideally one of the two top connections would > still connect to the wheels (so you could short it if you wanted the standard > behavior). > > I'm thinking of building a switching car with a Scout in it which is commanded > by a (stationary) RCX. The Scout would drive around the switchyard to build > trains based on information sent via IR from the RCX. I've always wanted a > computer controlled train layout AND a LEGO train layout, so this is my > excuse! I'm sure going to be poor after buying all the track and switches I'll > need, though! > > --Ben I've done just that. It's easy. I added a second wire directly to the motor. It even has little eye connectors for putting the wires. To avoid the motor from going to the main power I simply put electrical tape over the pressure pressed power connectors inside the unit. The hardest part was feeding and securing the new wire out of the unit (out the front beneath the ax power connector). You have to be careful to make sure it doesn't rub on the axle inside. Over time it could wear thing and cause a short. So my track feeds the aux connector that feeds the lights and my Lego RCX power connector. Then the RCX is always powered and controls my train. Pics available if necessary. Dean

Message has 2 Replies:

		Re: Has anyone disassembled a 9v Train Motor?
(...) How do you get it apart? How do you like your design in practice? I would like to see pictures of your whole engine, if you have them handy. Using the track to power the RCX was one of the ideas I was considering. The other was using the (...) (25 years ago, 3-Jan-00, to lugnet.trains, lugnet.robotics)

		Re: Has anyone disassembled a 9v Train Motor?
Sooner or later I'm going to try what I talked about in another thread - pulling the motor out of the shell, and adding in a capacitor and other circuits, so that the capacitor feeds non-stop 9V to lights or other circuits, while the "main" circuit (...) (25 years ago, 3-Jan-00, to lugnet.trains, lugnet.robotics)

Message is in Reply To:

		Has anyone disassembled a 9v Train Motor?
Has anyone investigated the possibility of disconnecting the motor from the pickups on the wheels so it can be powered from the top plate without driving other trains on the same track? Ideally one of the two top connections would still connect to (...) (25 years ago, 3-Jan-00, to lugnet.trains, lugnet.robotics)

6 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Active threads in Robotics

	Verified and Trusted Team of Hackers 7 hours ago

Custom Search