| |
> Hi,
>
> I'm trying to download pbForth onto my RCX.
>
> I'm using NQC on NT and have downloaded the latest pbForth: 1.1.1
>
> I'm invoking NQC with: "nqc -firmware pbforth.srec"
>
> I get the dots crawling across the command-prompt window. When they
> almost reach the right hand side, the transfer always stops with:
>
> "No reply from RCX"
>
> Does anyone have a clue what the problem might be ?
>
> (The H/W is in a darkened place, IR set to FAR etc...)
It's working just fine. If the LCD says "4th", then the firmware is in
place, now all you need is a terminal set to 2400,n,8,1
By the way, this kind of question should be on the lugnet.robotics.rcx.pbforth
heirarchy...
Cheers,
Ralph Hempel - P.Eng
--------------------------------------------------------
Check out pbFORTH for LEGO Mindstorms at:
<http://www.hempeldesigngroup.com/lego/pbFORTH>
--------------------------------------------------------
Reply to: rhempel at bmts dot com
--------------------------------------------------------
|
|
Message is in Reply To:
 | | pbForth problems
|
| Hi, I'm trying to download pbForth onto my RCX. I'm using NQC on NT and have downloaded the latest pbForth: 1.1.1 I'm invoking NQC with: "nqc -firmware pbforth.srec" I get the dots crawling across the command-prompt window. When they almost reach (...) (27 years ago, 30-Dec-99, to lugnet.robotics)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
