To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 8111 (+5)
  Re: Homemade LED Bricks
 
David Johnston <lego-robotics@crynwr.com> wrote in message news:LOBBJCENKNHFLCK...inet.ie... (...) I'd say 330 Ohm 1/4 Watt. (27 years ago, 12-Nov-99, to lugnet.robotics)
 
  Re: Homemade LED Bricks
 
(...) Er, 330 ohm may be ok for the usual transistor type circuit where the nominal supply voltage is 5 volt, if my memory has not failed me. It may be a bit low, I think, for the RCX where the nominal voltage is 9 volts which is almost double of 5 (...) (27 years ago, 12-Nov-99, to lugnet.robotics)
 
  Re: Homemade LED Bricks
 
basicly.. it's i*r=v where i = current in amps and r = resistance in ohms and v = voltage in volts.. so.. If we want to find out the resistor's value.. we re arrange it like so.. r = v/i so 10 millamps (typical led current) = .01 Amps.. And at 9 (...) (27 years ago, 12-Nov-99, to lugnet.robotics)
 
  Re: RIS 1.0 to 1.5 software upgrade
 
Hi! I got a RIS 1.0 in October. I called up Lego Consumer affairs to ask for an update kit for $3.95. They said it is only possible if I had bought from S@H. They also say that it is available to only those lego RIS which have a sticker on the box. (...) (27 years ago, 12-Nov-99, to lugnet.robotics)
 
  Re: Homemade LED Bricks
 
grrr.. I flubbed.. instead of r = .01/9 make it r = 9/.01 ----- Original Message ----- From: Keith Miller <kmiller@talon.net> To: <lego-robotics@crynwr.com> Sent: Thursday, November 11, 1999 10:23 PM Subject: Re: Homemade LED Bricks (...) (27 years ago, 12-Nov-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR