To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 743
    Re: legOS —Bill Hollingsworth
   Hi, Thanks for your response. I have been reading your pages over the past few days. I do not have the RCX (yet), but I am very interested. I learned of it this weekend and have been reading the specs. I am as interested in playing with operating (...) (26 years ago, 25-Nov-98, to lugnet.robotics)
   
        RE: legOS —Vadim Strizhevsky
   (...) For some Pilot <--> RCX information take a look at (URL) if you haven't yet. This honestly is quite lagging on progress, but I _have_ been working on it in my very limited spare time. Hopefully within a week or two I'll have some much more (...) (26 years ago, 25-Nov-98, to lugnet.robotics)
   
        Re: legOS —John Donaldson
    Has anyone be able to unpack the LegOS file. I have the CYGNUS GCC on my Wintel system. Using GZIP I get this error "Invaled Compressed Data - Format Violation" I would like to try out LegOS and see if it will allow memory storage/retrieval. I have (...) (26 years ago, 24-Nov-98, to lugnet.robotics)
   
        Re: legOS —Bill Hollingsworth
   (...) Hi, You can get legOS at (URL) . There is a note that some people have a problem with the file after downloading. Instead of clicking on the file, right click and select save link. It will save as legOS-0.1.2.tgz . Then run tar -xzf (...) (26 years ago, 25-Nov-98, to lugnet.robotics)
   
        Re: legOS —John Donaldson
    I have downloaded OK and since it is both tared and zip, you hve to first unzip it using "GZIP". GZIP is like Compress. Gzip (compress) -d legOS-0_1_2.tgz - uncompress the file tar -xzf legOS-0_1_2.t unarchive it. I am getting the error when I try (...) (26 years ago, 25-Nov-98, to lugnet.robotics)
   
        Re: legOS —Bill Hollingsworth
   (...) Hi, When you run tar with the -xzf parameters, it first ungzips it then it untars it, all in the one command. The "z" is for gzip. The "x" is for extract the tar file. The "f" specifies the file. , __ _ _ , /|/ \o | | | | /| | | __/ | | | | (...) (26 years ago, 25-Nov-98, to lugnet.robotics)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR