Subject:
|
Pnumatic Vavles for Mindstorm
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sun, 22 Nov 1998 06:53:44 GMT
|
Original-From:
|
Nancy Evelyn Gold <nancyg@sgi.com&NoSpam&>
|
Viewed:
|
2154 times
|
| |
|
|
Check out http://www.numatech.com/s-valve.pdf
Look like a three-way in-line vavle could make a good replacement
for the manual LEGO vavle. 5ms response time.
Thoughts?
I'm willing to but a couple of samples and attempt to build a workable
piece. If it works I'd also be willing to buy a quanity and fab a bunch.
--- Nancy
--
Nancy Evelyn Gold (nancyg@sgi.com)
1993 BMW K1100LT "Chloe" - DoD# 1184 - BMWMOA
++ Only Open DVD Delivers! Just say no to DIVX. ++
|
|
Message has 2 Replies:
 | | Re: Pnumatic Vavles for Mindstorm
|
| (...) Well I must admit that this and the shape memory wire idea are the first two things I've heard suggested that might tempt me away from my official-LEGO-only attitude. The standard LEGO pneumatic valves are no fun at all (who'dathunk they'd (...) (26 years ago, 22-Nov-98, to lugnet.robotics)
| | | Re: Pnumatic Vavles for Mindstorm
|
| Nancy Evelyn Gold wrote in message <3657B4F8.F2C6E925@sgi.com>... (...) Be careful. Correct me if I am wrong, but the LEGO valve has a neutral position while these three way valves fully pressurize one port or the other. This is only an issue if you (...) (26 years ago, 22-Nov-98, to lugnet.robotics)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
