 | | Re: ideas for a RIS 2.0
|
| (...) If that were true, then the following multi-touch-sensor adapters would not work: (2 URLs) Robert Munafo (URL) LEGO: TC+++(8480) SW++ #+ S-- LS++ Hsp M+ A@ LM++ YB64m IC13 (27 years ago, 24-Aug-99, to lugnet.robotics)
| | |  | | Obj.: r/c servos
|
| To add more to all those servo information, I've build a servo controller which use the printer connector on the PC. It doesn't use any electronic, everything is made by software (Delphi 3.0) It is quite usefull to try this at home since you'll (...) (27 years ago, 23-Aug-99, to lugnet.robotics)
| | |  | | Re: ideas for a RIS 2.0
|
| (...) gradually depress the sensor. There is not a sharp cutoff like there is with a typical contact switch. I tried building a touch sensor multiplexor, but I was unable to reliably get even 3 to work because the minimum resistance is quite large (...) (27 years ago, 24-Aug-99, to lugnet.robotics)
| | |  | | RE: ideas for a RIS 2.0
|
| (...) But it IS true, and that's why the 6 input mux at: (URL) has some problems. Find out for yourself by putting a meter across a touch sensor. The resistance changes from about 1K to 470R when pressed depending on how hard it is pressed. Michael (...) (27 years ago, 24-Aug-99, to lugnet.robotics)
| | |  | | Macintosh IR cable
|
| Hello, I just talked to Pitsco LEGO DACTA. I was curious about the IR tower they sell, because it comes with a Macintosh cable. It turns out that the cable is available separately, item 4119830, for $15. This item is not listed in the catalog (...) (27 years ago, 24-Aug-99, to lugnet.robotics)
| |