To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 5966 (+5)
  RCX battery cover
 
I noticed that the battery cover on the bottom of my RCX is really loose. So loose that I wouldn't risk holding the thing upside down by the cover (since i'm afraid it would come off). Has anyone else noticed this? Marty. -- Did you check the web (...) (27 years ago, 2-Aug-99, to lugnet.robotics)
 
  RE: MN FIRST Lego League page
 
(...) Thanks! Compliments from this group mean a lot! BTW, Kenny's team was 3 third grade girls. Very Impressive. Dead reckoning worked the fastest but was very dependent on battery power. Their approach was more robust than most. Also, ROBOLAB will (...) (27 years ago, 2-Aug-99, to lugnet.robotics)
 
  Re: output A in reverse weak and NQC question
 
(...) Both motors work fine in both directions when attached to output C. It's only outputs A and B where I have a problem. There's so little power in the "weak" direction from A and B that they can't drive the caterpillar tracks. Tim Tim Gion (...) (27 years ago, 2-Aug-99, to lugnet.robotics)
 
  Re: RCX battery cover
 
yup! (...) (27 years ago, 2-Aug-99, to lugnet.robotics)
 
  Re: RCX battery cover
 
(...) Yeah, you pretty much have to make sure your design holds the battery cover on, for example by having beams both underneath and on top of the RCX, held together with vertical beams and connector pegs. This can be a bit of a challenge if you (...) (27 years ago, 2-Aug-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR