To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 5659
    Re: Sensor Reliability —Ben Williamson
   (...) You can also get fairly good results from using boiling water and ice water for 100 C and 0 C respectively. It helps to put the ice water in a foam cup with a hole in the lid for the sensor, and leave it sit for a few minutes to give the water (...) (25 years ago, 14-Jul-99, to lugnet.robotics)
   
        Re: Sensor Reliability —Robert Munafo
   (...) Don't boil your LEGO bricks. They start to get soft at 80 degrees Centigrade. For more information, read from the chronicles of Dr. Franzenstein: (URL) Robert Munafo (25 years ago, 14-Jul-99, to lugnet.robotics)
   
        Re: Sensor Reliability —Ben Williamson
     (...) Indeed. I was thinking more of homebrew sensors. Of course, these need to be electrically insulated before dunking in liquids, to avoid false readings. Cheers, - Ben. ---...--- Ben Williamson benw@pobox.com (URL) you check the web site first?: (...) (25 years ago, 14-Jul-99, to lugnet.robotics)
   
        Re: Sensor Reliability —Shawn Menninga
   (...) And don't forget that the boiling point of water varies *significantly* with altitude above sea level. The higher up, the lower the boiling point. -SMQ Shawn Menninga smq@dwarfrune.com --=--=--=--=--=--=--...-=--=--=-- "Well I've wrestled with (...) (25 years ago, 15-Jul-99, to lugnet.robotics)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR