 | | Re: What is RPM of Gear Motor???
|
|
Keep checking the math. I clocked the motor at 330 - 350 rpm. I used the rotation sensor driven directly by the motor. From analysis of the RCX firmware, the rotation sensor should be accurate to 1250 rpm, so I'm pretty confident of it being in the (...) (27 years ago, 6-Jul-99, to lugnet.robotics)
|
| |
 | | Re: Virtual PC and Mindstorms
|
|
Robolab uses the same RCX as Mindstorms - I have one of each and they are identical (short of the number stamped on the side). Dave (...) reply to: dbaum at enteract dot com (27 years ago, 6-Jul-99, to lugnet.robotics)
|
| |
 | | Re: What is RPM of Gear Motor???
|
|
(...) Dave- Where are you getting that 1250 rpm upper limit from? While I haven't counted exactly yet, I'm dropping only 20 counts out of every thousand at ~15,000 rpm. I had assumed this was mainly gear slop, since it only appears to occur while (...) (27 years ago, 7-Jul-99, to lugnet.robotics)
|
| |
 | | Re: What is RPM of Gear Motor???
|
|
Using a Futaba 9ZAP radio with a built in optical tachometer and the two bladed LEGO prop I got 380 rpm for the gearhead motor and 4320 rpm for the older nongeared motor. Of course this was done with a battery box and brand new batteries so I am (...) (27 years ago, 7-Jul-99, to lugnet.robotics)
|
| |
 | | Re: What is RPM of Gear Motor???
|
|
My memory is a bit fuzzy here since it was a while back, but according to my notes... * sensors are sampled every 3ms * rotation sensor is a quadrature encoder with a 4:1 gearing in front of it (one rotation of the axle yields 16 "ticks"). * sensor (...) (27 years ago, 7-Jul-99, to lugnet.robotics)
|