 | | Re: Problems with RCX, ROBOLAB and Macintosh
|
|
Hallo, I have tried NEW batteries in ir tower and RCX. I have tried to communicate in an absolute dark room with the same results. The ir tower is in near mode and the RCX in reset mode (take out the batteries and switch on the RCX - put the (...) (27 years ago, 6-Jun-99, to lugnet.robotics)
|
| |
 | | Anyone have any luck making a successful floating boat?
|
|
I was just wondering if anyone has had (or even tried) making a successful floating boat (not using the "Boat Really Floats" pieces)? -- Clay Aucoin (27 years ago, 14-Jun-99, to lugnet.robotics, lugnet.build)
|
| |
 | | Fw: Problems with RCX, ROBOLAB and Macintosh
|
|
I've seen this thread going, and going, and going; must be pretty frustrating. It seems like you said at one point that it works fine from a PC, is that right? If so, don't you have to use a serial adapter to connect the IR tower to a Mac? And if (...) (27 years ago, 13-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Problems with RCX, ROBOLAB and Macintosh
|
|
Hallo Will, it can't be the adapter cable which is wrong. With NQC -the very good programming software from Dave Baum- I have no problem to contact the RCX. Downloading the firmware, sending programs, starting programs ... it's okay. Everything (...) (27 years ago, 14-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Anyone have any luck making a successful floating boat?
|
|
(...) I've considered using empty air tanks from pneumatic LEGO sets as sort of 'pontoons'... my one quick test of this so far was too top-heavy (I only have three air tanks), but it seems like it should work, as long as the floats are far enough (...) (27 years ago, 14-Jun-99, to lugnet.robotics)
|