 | | Re: micro motor sometimes stuck
|
|
(...) does. Use it only for low-torgue applications, and try not to stall it. -- Did you check the web site first?: (URL) (27 years ago, 8-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Removing red led from light sensor..
|
|
Jeff Blaine <jblaine@shell2.shore.net> wrote in message news:slrn7lvneh.n11....ore.net... (...) A simulation of the LEGO Light sensor circuit I did in PSpice showed that the sensor wouldn't read down to zero just because the way the LED interacts (...) (27 years ago, 10-Jun-99, to lugnet.robotics)
|
| |
 | | Re: Robotic Pool Cleaner (Non-Lego Alert!)
|
|
I got a private reply from Bill Leggett about this device: (...) So it sounds like this thing boils down to some very clever mechanical engineering, but no software or electronics or anything. Still interesting to a robotics fan, but in a different (...) (27 years ago, 10-Jun-99, to lugnet.robotics)
|
| |
 | | Re: micro motor sometimes stuck
|
|
(...) Well, I thought the reason that we always attach that pulley-with-rubber- lining thing (See (URL) for "friction pulley") to the micro motor is to avoid stalling the motor -- If the torgue is too high the friction pulley will slip. Apparently (...) (27 years ago, 11-Jun-99, to lugnet.robotics)
|
| |
 | | Re: micro motor sometimes stuck
|
|
Wow. I never noticed the rubber in those pulleys before. So you insert the axle just far enough to engage only the rubber lining? It seems that if you put the axle all the way through there is no slippage. (...) -- Did you check the web site first?: (...) (27 years ago, 11-Jun-99, to lugnet.robotics)
|