I think I read someplace that if you remove the red led from the light sensor it works much better. Has any one done this and if so how did it work? (25 years ago, 10-Jun-99, to lugnet.robotics)
(...) Ralph Hempel describes some non-destructive tricks to get better readings from a light sensor. This is the address: (URL) (25 years ago, 10-Jun-99, to lugnet.robotics)
Patrick Lawrence <pat@hpnc.com> wrote in message news:FD3pFv.DDF@lugnet.com... (...) Removing the LED makes it work over a wider range (0 to 100), but probably at a slight loss of low light sensitivity. There is an analysis of the subject in the (...) (25 years ago, 10-Jun-99, to lugnet.robotics)
Thanks for all the advice. I got the parts from radio shack and just made a new light sensor today. Now its time to start working with NQC or GORDON'S BRICK PROGRAMMER or somthing. Patrick Lawrence wrote in message ... (...) (25 years ago, 12-Jun-99, to lugnet.robotics)
