To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 5281 (+5)
  Removing red led from light sensor..
 
I think I read someplace that if you remove the red led from the light sensor it works much better. Has any one done this and if so how did it work? (27 years ago, 10-Jun-99, to lugnet.robotics)
 
  Trouble getting VB sample prog working
 
Hello, I've been having trouble getting a couple of the various sample VB programs to work (such as the one that can be found on the official Mindstorms site) - every routine call seems to be coughing up this error: "Remember to call Init Comm or (...) (27 years ago, 10-Jun-99, to lugnet.robotics)
 
  Re: A synchro-drive and a CyberDog
 
In lugnet.robotics, Hari Wiguna writes: <snip> (...) Yes, correct. You "drive" it more or less you'd do with a real dog. And when you pull up the leash, it stops. Mario (27 years ago, 10-Jun-99, to lugnet.robotics)
 
  Re: Removing red led from light sensor..
 
(...) Ralph Hempel describes some non-destructive tricks to get better readings from a light sensor. This is the address: (URL) (27 years ago, 10-Jun-99, to lugnet.robotics)
 
  Re: Removing red led from light sensor..
 
It is actually easier to just place a beam in front of the sensor. The layout of the hole on the beam will block out the LED adn allow you to just use the sensor. DAN In a message dated 6/10/99 6:42:02 AM Eastern Daylight Time, mario.ferrari@edis.it (...) (27 years ago, 10-Jun-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR