To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 486 (+5)
  Re: Multiplexing Input Circuit
 
(...) Looks good! How about using the third input port to assert the reset line and set the counter back to zero? Is your counter set up as a binary counter? From your diagram it looks like there are times that more than one sensor would be active (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
 
  Re: Multiplexing Input Circuit
 
(...) The counter is a CMOS decade counter that has only one output high for each count. There is only one analog switch on at a time. The counter is reset when it hits the value 5 so it jumps back to 0 to start over. The analog switch is (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
 
  Re: Tachocount
 
(...) I'm sure the motors may be used for other things as well, albeit not as easily as separate motors. (...) But in a program you will always know which way the motors drive, right? So one can possibly maintain a second variable for each motor (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
 
  Re: Multiplexing Input Circuit
 
(...) The setup I was using was bi-directional too, I'm not sure exactly why I was seeing it, but I remember getting a high reading for a non-pressed touch sensor when the next one over (the previous one in the cycle?) was pressed. If I reversed the (...) (28 years ago, 12-Nov-98, to lugnet.robotics)
 
  Re: A spider (legged) RCX robot
 
(...) for moving the legs up and down very thoroughly, but not the rotating of the legs. The first time I saw the article, I thought the model moved by always keeping at least four legs fully extended. I later learned that this was not true, but I (...) (28 years ago, 12-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR