To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 4531 (-5)
  Re: **lego motors?**
 
(...) I don't think that it would take up a lot of space at all. In fact, the largest part should be the motor that is used to engage/disengage the gear. Using a tractor hub, two 16-T gears, and two axles (with other parts to hold this all together, (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Dark seeker project
 
I have finally built a creation with my Mindstorms kit that uses all of the sensors (some twice) and all of the motor connections! It has two bump switches for a collision detector on the front, one of my RCX IRPD modules to try to detect potential (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Re: clutch gear
 
(...) No, but it's probably the cheapest, unless it's in a Dacta spare parts kit I don't know about. Target had the 3735s on sale for over 50% off. It's also in the 8479 Bar Code Multi set, but that's $160. These are the only two sets that have it (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  clutch gear
 
Is the motor kit the only way to get a clutch gear? Joel Shafer joel@connect.net -- Did you check the web site first?: (URL) (28 years ago, 12-Apr-99, to lugnet.robotics)
 
  wall-follower using Dennis Clark's IRPD
 
Earlier this year I tried building a wall-follower using RCX's built-in IR port as the proximity detector. However I could not get consistent readings from the light sensor to make it work. I thought it was because the SendMessage trick did not turn (...) (28 years ago, 12-Apr-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR